Aerosol spray adhesives from the 3M industrial range

  • Complete range of 3M aerosol spray adhesives
  • Full reference list
  • Key product characteristics
  • Technical expertise

Quote

Close

Overview

          Description of 3M industrial spray adhesives

    Spray adhesives come in an aerosol can, making them easy to use and maneuver. They can provide permanent bonding or be repositionable, with a wide range of applications such as bonding photos, foams, decorative fabrics, and expanded polystyrene.

     

    This type of adhesive is classified as flexible and is non-structural. Bonding occurs through the evaporation of the solvent.

     

    There are considerations for open time (the time after applying the adhesive during which bonding can occur), which are noted in the technical data sheets.

     

    Depending on the references, a single and/or double coating may be required.

     

    For a quick reference, here’s a summary of the main applications for each product:

    If you would like more technical information about these products, please discover all the characteristics of the spray adhesives.

     

    It is important to note that some of these adhesive references are available in pressurized canisters for large-volume industrial applications.

     

    Not all products from the 3M industrial range listed in the catalog are available on our site. However, we can provide you with a quote and supply the product you are looking for according to your needs. Don’t hesitate to contact us!

          How to use a 3M aerosol?

    Here’s a summary table outlining the steps for optimal use of a 3M spray adhesive:

    StepsUsage Procedure

    Step 1

    Align the arrow on the nozzle with the black dot on the aerosol. 

    For aerosols with multiple flow options, select the desired flow rate (L: Low, M: Medium, H: High). 

    Shake the aerosol well and purge the nozzle by spraying briefly into the air.

    Step 2

    Spray at a 90-degree angle and 20 centimeters from the surface to be bonded. 

    For better edge adhesion, first spray around the substrate. 

    Then, lightly spray while moving the nozzle at a consistent speed to cover the surface with a uniform layer. 

    If double coating is required, repeat the same operation for the second substrate.

    Step 3

    Wait a few seconds or minutes according to the open time. 

    Perform the assembly and apply uniform pressure from the center outward to achieve good adhesion.

    Step 4

    		To prevent the nozzle from clogging, at the end of each usage day, turn the aerosol upside down and press the nozzle until no adhesive remains.

          Summary table of references

    ReferenceProduct DescriptionQuote
    3M 71Special composite, 500 ml, transparent or greenQuote
    3M 720Special textile, 500 ml, transparentQuote
    3M 74Special for soft foams, 500 ml, lace spray, orange, double coatingQuote
    3M 75Repositionable for mobile labels, 500 ml, clear color, temporary bonding, particle spray, transparent, single coatingQuote
    3M 76500 ml, cream color, high performance, long open time, splash spray, single or double coatingQuote
    3M 77Multi-purpose & polystyrene, 500 ml, particle spray, translucent, single or double coatingQuote
    3M 80Special vinyl - neoprene, 500 ml, yellow, lace spray, quick bonding, high resistance, double coatingQuote
    3M 90High performance, 500 ml, white, lace spray, quick bonding, high resistance, double coatingQuote
    3M DisplaymountDressing and decoration (e.g., 7077), 400 mlQuote
    3M PhotomountPermanent mounting (e.g., 7024), 400 mlQuote
    3M RemountRepositionable, 400 mlQuote
    3M SpraymountSequential mounting (e.g., 7043), 400 mlQuote